Product Reviews

All of the Double Alpha products for reloading have been good additions to my reloading set-up. As I add additional machines I return to the Double Alpha site to purchase the same upgrades for my equipment. I currently have multiple Mr. BulletFeeders and when I had a problem with one of the motors Double Alpha was quick to respond to my issue and provide the necessary motor at a very reasonable cost.

At first, I loved that you could adjust these in so many different ways. Then I realized how difficult it is to set them up. It took hours to find angles the worked for me. This meant loosening and tightening the torx screws A LOT. Not only did I strip a torx screw, but I completely disabled its use until I find another screw to replace it. DAA offered to replace th hangers, which is great...but the product design itself is flawed. You should figure out a way to utilize a QD locking mechanism instead of a torx screw. The torx screw is it's weakest point. I had a better experience with your Racer mag pouches that didn't use a ball joint hanger. I had high hopes for this mag pouch and was let down.

Excellent item very good service quality part

Save yourself time and buy it. So glad I did. It loads all tubes with brass in under 4 minutes.

Works great! Viewing the video on setup made it easy to setup and mount to my press. Just need to take your time cycling the press and watching the process. Still faster and easier than hand feeding brass. I reload .45 Colt and 44 Mag and had to modify the .45 ACP orange tube by filing it out. I also had to file out the hole on the bottom of the case feeder magazine tube as well so brass would drop through it. Double Alpha sent me instructions on how to do this. I would recommend to a friend.

Purchased mine in April, just got around to using it last month. It is a great accessory and I really like it. Simple to use, fills quick, and lets me have an extended load session without high dollar automated feeders. Like another recent reviewer I also had to sand parts quite a bit in order for them to fit. My Dillon case feeder tubes for 4 calibers were all at least .020" larger than the ID of the case feed adapter. The angled end that fits over the threaded stud on the press was significantly smaller and required drilling with a letter bit so it would thread on the stud. Once those alterations were made the case feeder works as advertised.