Product Reviews

Not that I need the additional speed in my 1050 / Mark7 setup but I do need a more reliable case feed vs the original Dillon case feeder plate. This is what I got as I now have 3000 9mm cases through the manchine and until now I did not have a single hang up and neither did I have an upside down case, clearly a much better performer than the original dillon case feeder plate.

I have purchased 1 additional powder measure system for my 550c, right now I have one set with a large powder bar for rifle loads and one with a small powder bar for pistol loads, I’m looking to add a third one so I can leave my 223 and 9mm powder throws alone since I use them so much. Eventually after that I will add a 4th.

These are a must. I purchased my first few when I got my quick change mount for my 550c and had to have more. Simple yet effective design, much sturdier than the 3D printed design. Well worth the money!

I bought a second tube so that I could cut back on my time spent “off the press” especially for 223, having the second tube allows me to stay on the press and “in the groove” longer and allows me to increase my productivity. I just wish they had a cover for the top and a mount for the table but I’m working on something for that on the 3D printer.

As with any and everything Dillon it is a flawless product. I have the 357/38 spl, 9mm, 380, 40 S&W/10mm, 45 ACP, and the 223 versions. All are exactly as you would expect from Dillon.

Maybe its just the batch I received but both the pick-up tips and fill tips are tighter than they should be, resulting in more finger pressure being required to get primers out of the flip tray and the occasional stuck primer when filling my press. I made sure both ends were pressed all the way in and that did not fix the issue. It may also be the brand of primers I'm using (CCI) but my blue brand tubes have zero issues with the same primers and the tubes should work with every brand. I've been happy with other DAA products but these missed the mark for me.