Product Reviews

If you are buying for Sti older model wait till they have the Muzzle support trigger gaurd is to round and rocks back and forth also a block could be a little deeper

I'm updating a review from 11/24/22 where I said primers occasionally don't feed correctly or go in upside down. I figured out it was pilot error so I changed from 4 stars to 5 stars. The tube has to be fully seated in the Primafill. I also had to chamfer the mouth of one primer tube to keep the primers from sticking. I've loaded Federal, CCI and Winchester small pistol primers so far and I am using RCBS, Dillon and FA tubes with the Primafill. They all work very well. This loads 100 primers so fast it's hard to believe. I have loaded about 7000 primers and after I figured out my problem I have not had ANY issues. I would and do highly recommend this to my friends.

Well this is just a fantastic bit of kit. My bullet supply is a little dry at the minute and I'll buy what I can get my hands on. This meant constant fiddling with spacers and I still wouldve got the odd upside down head. Not any more! This is a great upgrade to Mr Bullet Feeder and allows me to make minor tweaks with a turn of a screw or two. They're cheap enough to have a few for different calibres so I'll be picking up a couple more with my next order.

Haven't had a case jam or upside down feed since changing to this plate. I don't usually run the case feeder at full speed because I take my time reloading but I'd be confident that it would go at full tilt without any issues. Would highly recommend this as an upgrade.

A huge improvement over the shorty little dillon blue wedges and is an easy inexpensive upgrade for any caliber dillon feeder. For high speed 9mm use, also get the plate. It will easily outrun a roll sizer set at full speed.

An easy 5 stars. I roll sized 2 full 5 gallon buckets of 9mm brass and only had 3 jams and NO cases upside down. This plate will outrun using 6 bolts on the roll sizer while the case feeder is not even close to full speed. With this thing having many more slots for the holes, it does not have to run anywhere as fast as the dillon plate to deliver a much higher output of cases. And the pull ring to remove it is a convenient nice touch. If you are tired of the Dillon plate jamming with the 9mm case between the plate and the little blue wedge, this combo is a no brainer and worth every penny.