Product Reviews

This is a really good product, that is really close to being awesome. Betting in couple generations, it'll be just about perfect. This item works rather well once it is set up, and makes progressive reloading far easier. Lock out dies, and powder check dies have got nothing on this. The dillon powder check leaves much to be desired, especially compared to this. Couple of improvement areas are there. First.. setup can be finicky. If they placed some sort of indicator on the magnet or sensor it would make it so much easier. Either a pair of marks on the magnet and sensor to line up, or line the top of the magnet with the top of the sensor body so to line up center of magnet with center of sensor would be excellet. Next. all adjustments are done with an allen wrench. A storage point for the allen wrench would be great.

I love these mag pouches. However the size has been reduced recently and the standard one will no longer fit 2 1911 mags in the 6 pockets. I ordered 4 new ones a week ago and none of them can fit two 1911 mags in the pocket(very tight fit). I have 2 old "standard" pouches and they can fit 12mags no problem. When I put the old design and the new one side by side, there's clearly a size difference. Was this size reducing done on purpose or no, I don't know. Double Alpha needs to answer that. I knocked off one star because of the reduced size because the description clearly says "Holds 6 double stack mags or 12 single stack mags". Good luck fitting 12 1911 mags in there. Its not gonna happen.

I purchased this after seeing on Utube. I am using it on Hornady LNL case feeder. I bored a Flat washer out to fit shoulder on clutch hub to get height for 38 Special. Reinstalled and adjusted tension on clutch. With this Plate and Diverter I have fed over 1000 cases of 9mm and 38 Special with no jam or misfeed. Absolutely recommend for Hornady Case Feeder. PROBLEMS SOLVED.

It works flawless. Much better choice than the standard Dillon setup.

Works great with powder checker and bullet feeder. I also like using the hex wrench to adjust drop lock in place and I think it’s a better option then the Dillon factory drop. Too bad it just didn’t come with the Dillon powder dropper or with the mr bullet feeder

Works great. The Dillon plate was having problems with cases getting stuck on the wedge switched to double alpha runs like a champ, not one stuck case as of yet. I have only tried 9mm looking forward to seeing if it work as well with other caliber’s