Product Reviews

I will explain below why I didn't give this 5 stars. Once I received the machine I followed the instructions on setting it up, particularly the section on setting the decapping die. I was somewhat disappointed on the results. An estimate of a 10% problem rate of jams or failure to remove the primer. I reached out to the Rollsizer support number and was surprised that I received a call from Australia to discuss my problem. It appears there was an updated manual that changes the setting of the decapping die. Once this was reset there was a significant improvement. However, I was still having more problems that I felt a machine of this cost should be having. Tech Support stated they had an updated wearplate that was available. I ordered one and once installed I am very pleased with the results. With the updated decapping die setting and the updated wearplate in place it is rare to have a jam. This is not to say 100% of the brass will be decapped. Some primers (particularly crimped) are not fully removed, but with the upgrades, do not cause a jam. With the all the improvements in place I am very pleased with the results. What rubbed me the wrong way was having the purchase an updated wearplate ($75 with shipping) to get the machine to run properly. Hopefully this, and the updated manual, is included with the new machines. I also have a few recommendations: - Purchase extra pins - I also purchased an extra rod that the pin fits. - I keep my hand on the off switch so I can quickly stop the machine if there is a problem - NORMA brass will most likely cause a problem.

It works perfect! Nice fitting, easy to assembly. The video tutorials are very useful. With 2 insert I can use all my guns! Nice!

Great tumbler A +++++++++++++++++++++++++++++++++++++++++++++++++++++++

Good product and sits well and gives good lighting while reloading.

These are the best bullet dies assemblies by FAR!!!!

Works great, it is far superior to the Dillon case feeder.