Product Reviews

After buying an owning a Dillon S1050, I bought an Apex-10. It takes a while to get to know, understand, set up and work in the Apex-10. But once it's dialed in, it runs like a hot knife through butter. After a while I decided to automate the Apex-10 and added a bunch of sensors ... sweet! Also good support by DAA and the Mark 7 crew!

[DAA reply] The connector can only pull off the board if there is considerable force applied to it. If you position the controller too far away, so that the wire is pulled tight each time the toolhead moves – you may damage the connector. All the same, we will replace it for you. Please ensure you position the controller in such a location as to avoid all tension on the wire. Review: I bought and installed the led lighting on my automated Apex-10. Following Saul's video instructions I installed the light smoothly and initially I was very pleased, especially with the adjustable "flood" of light. But during my last reloading session this weekend, the light did not work anymore. Upon inspection, the socket where you plug in the power plug was broken off. Looking in closer I noticed that most of the small pins were broken off, disconnecting the entire socket. I think the socket is too weak and the point of failure of the led light, especially after "longer" use. I now use a regular light.

This works great. When you're busy priming and checking each case, this will stop the machine before you run out of primers. Great product!

This works perfectly. Once set up, it flawlessly performs. I would recommend this for anyone using a Mr. Bullet Feed.

Not really using as intended. I wrap around vertical support beam and attach CED 7000 for solo practice. Helps pick up only my shots. Works well for stationary firing position.

Works well with my belt. Solid connection, simple implementation. Very pleased.