Beats the heck out of the original shell plate. Worth every penny! So don't just sit there and put up constant jams order this fantastic shell plate and enjoy flawless case feeding! Oh by the way tell them John sent you!!!!

Upped my game for speed. I can run my Rollsizer Decapper and Rollsizer at full speed. This plate makes a huge difference ! Thanks !

Works as described, I have 2 of the older dillion case feeders and not one issue since I put these in. One is on a rollsizer that ran about 7000 rounds without a stoppage

This has been a marvelous upgrade. It eliminated the frequent jams that that were occuring in the case feeder. I can now run it at full speed for feeding my rollsizer. Before the upgrade, the feeder was very frustrating with cases jamming between the plate and the flipper ramp every few seconds. The ramp became more damaged with each jam, increasing the jam frequency until it was virtually unusable. I think Dillon's version is a bad design as it exposes the edge of the ramp to the case mouth where it can catch. The DA design does not. I also no longer get occasional jams at the bottom of the hopper either.

Put this on my RL1100 and it works as advertised. The Dillon factory wedge didn’t work well, the edge of cases would get caught on the edge of the wedge and stop the plate. Once that happens and the wedge gets a ding in the edge it will never work right. The DAA is a much harder plastic and shaped better. Ive run about 2000 rounds with it without a stop or an inside down case. Highly recommended.

Not that I need the additional speed in my 1050 / Mark7 setup but I do need a more reliable case feed vs the original Dillon case feeder plate.

This is what I got as I now have 3000 9mm cases through the manchine and until now I did not have a single hang up and neither did I have an upside down case, clearly a much better performer than the original dillon case feeder plate.