Mr.BulletFeeder by DAA Die Assembly Only

Manufacturer
Double-Alpha Academy

Mr.BulletFeeder by DAA Die Assembly Only

Configure

Caliber

.223 .308 .40SW .45 6.5x55mm 9/38S

$57.95

in Stock

(157)

Qty:

Save for Later

Latest reviews

Dennis ***

22 Feb 2025

These bullet feeder/dropper die are so reliable and easy to use that I’ve bought 8 of them - where each is in a different die set for a Hornady LNL press (so there’s no adjustment needed when changing from one caliber to another)… and this works perfectly. The initial setup for the 7 die dropping...

Rating: (5 of 5 Stars!)

Scott ***

14 Feb 2025

This die is by far the best bullet dropper die available. They are easy to use and install. Took me less than a minute to screw it in and adjust to drop my bullets, it is beyond simple. What I like best about it is that it just works and keeps on working. I have experienced the other die on the...

Rating: (5 of 5 Stars!)

Tom ***

12 Aug 2024

Purchased the Mr. Bulletfeeder Die Assembly to use on a second tool head on my Dillon 650. This made changing toolheads by only disconnecting the Mr. Bullet feed line from one head and reconnecting it to the second toolhead a quick change. Received this item from Double Alpha promptly. I...

Rating: (5 of 5 Stars!)

Jeff ***

19 Nov 2023

Modified .308 bullet feeder die to use for .32 ACP using instructions found on the internet
Using Horandy single tube bullet feeder cut to hold 25 bullets, might work with more
Set up on Horandy LNL press, after some minor fine tuning it’s working well, loaded 400 rounds of.32 ACP with no...

Rating: (5 of 5 Stars!)

We Also Recommend

Mr.BulletFeeder by DAA Die Assembly Only

$57.95

Mr.Bulletfeeder Bullet Dropper Thread-Extention

Mr.Bulletfeeder Gen 1/2 Bullet Dropper Thread-Extention

$17.95

Get Stock Alert

Description:

The Mr.BulletFeeder die assembly is the “clever” part of the Dropper, the part that allows only one bullet to drop while retaining the rest of the stack.

Made of Anodized Aluminum, this assembly is caliber specific and includes a threaded die body, an inner aluminum dropper tube, a nut, clip and 3 steel balls.

This assembly is the same item used for both the Mr.Bulletfeeder and the Mini Mr.Bulletfeeder by DAA.

These Die assemblies are sold separately, to enable you to set up a 2^nd tool head, leaving the die correctly adjusted on each. If similar calibers are in use, such as 9mm on one toolhead and 38 on a 2^nd, you can transfer the upper part of the dropper from one to the other, leaving only the die on the dedicated tool head, permanently adjusted. This will save you buying a complete new dropper for the 2^nd caliber, and also mitigate the need to detach the wiring and the feed spring from the top of the dropper assembly as you switch over calibers..